This website requires certain cookies to work and uses other cookies to help you have the best experience. By visiting this website, certain cookies have already been set, which you may delete and block. By closing this message or continuing to use our site, you agree to the use of cookies. Visit our updated privacy and cookie policy to learn more.
This Website Uses Cookies By closing this message or continuing to use our site, you agree to our cookie policy. Learn MoreThis website requires certain cookies to work and uses other cookies to help you have the best experience. By visiting this website, certain cookies have already been set, which you may delete and block. By closing this message or continuing to use our site, you agree to the use of cookies. Visit our updated privacy and cookie policy to learn more.
Equipment Snapshot: With models for 250 and 500 bottles per hour, these fillers can be integrated with MicroThermics laboratory and small scale UHT, HTST and aseptic processing equipment to create a complete laboratory aseptic processing line. This equipment can fill 250 ml or 500 ml bottles. It allows for pre-process sterilization of the filling chamber, filling heads and product lines. Prior to filling, the filler’s chamber goes through a process where it is steam-sterilized. The sterilant condenses on all filler surfaces. After the proper exposure time, HEPA filtered air is blown through the chamber, removing the sterilant and maintaining a positive-pressure sterile zone. During this sterilization cycle, the product lines and filling nozzles are heat-sterilized with hot water from the MicroThermics UHT processor. After sterilization, processor and filler conditions are changed for product processing and filling.